Microsoft security update for CVE-2025-39801 — azl3 kernel 6.6.96.2-2 on Azure Linux 3.0
🔗 CVE IDs covered (1)
📋 Microsoft's advisory
EchelonGraph does not copy Microsoft's advisory page: its FAQ and remediation text are not shown here. Read the advisory on https://msrc.microsoft.com/update-guide/vulnerability/CVE-2025-39801. This page also shows what EchelonGraph holds for CVE-2025-39801, with the description from its CVE record, which the CVE Numbering Authority that assigned the CVE wrote: for a CVE Microsoft assigned, often in the words of Microsoft's own advisory.
🎯 Affected products1
- azl3 kernel 6.6.96.2-2 on Azure Linux 3.0
✅ Updates Microsoft lists: 1 update
1 row: one per KB article or update, update type and fixed build. Their details are on Microsoft's advisory.
| KB article | Update | Fixed build |
|---|---|---|
| — | Security Update | 6.6.104.2-1 |
🧭 EchelonGraph on CVE-2025-39801
- EchelonGraph score
- 5.5 MEDIUM
- CISA KEV
- Not listed
- Fix status
- A fix is available — apply it.
Description from the CVE record (CVE.org), as published by its numbering authority
In the Linux kernel, the following vulnerability has been resolved: usb: dwc3: Remove WARN_ON for device endpoint command timeouts This commit addresses a rarely observed endpoint command timeout which causes kernel panic due to warn when 'panic_on_warn' is enabled and unnecessary call trace prints when 'panic_on_warn' is disabled. It is seen during fast software-controlled connect/disconnect testcases. The following is one such endpoint command timeout that we observed: 1. Connect ======= ->dwc3_thread_interrupt ->dwc3_ep0_interrupt ->configfs_composite_setup ->composite_setup ->usb_ep_queue ->dwc3_gadget_ep0_queue ->__dwc3_gadget_ep0_queue ->__dwc3_ep0_do_control_data ->dwc3_send_gadget_ep_cmd 2. Disconnect ========== ->dwc3_thread_interrupt ->dwc3_gadget_disconnect_interrupt ->dwc3_ep0_reset_state ->dwc3_ep0_end_control_data ->dwc3_send_gadget_ep_cmd In the issue scenario, in Exynos platforms, we observed that control transfers for the previous connect have not yet been completed and end transfer command sent as a part of the disconnect sequence and processing of USB_ENDPOINT_HALT feature request from the host timeout. This maybe an expected scenario since the controller is processing EP commands sent as a part of the previous connect. It maybe better to remove WARN_ON in all places where device endpoint commands are sent to avoid unnecessary kernel panic due to warn.
Published by kernel.org, the CVE Numbering Authority that assigned CVE-2025-39801, in its CVE record at CVE.org; reused under the CVE Program's Terms of Use (its licence and MITRE's copyright notice are in our Terms of Service).